-
Dry full loads whenever possible to use even less energy
-
Only use one ball per load, remove all other dryer balls.
-
For washer dryers, do not put the ball in during the washing cycle. Pop the ball into the drum after your wash cycle.
-
HeatBounce™ technology becomes less effective with time. Replace the ball when the silver coating wears off the edges of the 'Boss It' logo; indicating reduced savings.
-
When your ball isn't saving you money anymore, send it back and we will recoat it for some-one else.
-
Laundry loads with hard surfaces such as belts, zips and buttons will cause the ball to wear faster.
-
If you have children in the house, leave the ball a few minutes before touching it as could get hot.
-
Make sure to still empty the condenser drawer and lint filter.
-
Careful when emptying the dryer that the ball doesn't bounce as this will cause extra wear.
FAQs
Collapsible content
What is the benefit of using Boss it Rapid Dryer Ball?
Save money & time drying your laundry with Boss it Rapid Dryer Ball.It makes your tumble dryer more efficent so you can save up to 40% on your dryer bill.
Do these actually work? and if so, how much time do you save?
Yes! We have lab tested over 5,000 hours of the drying time of wet laundry with no Ball (control tests), against wet laundry with Boss it and found that they reduced tumble drying time by between 30% and 40%. Depending on dryer type, wide range of fabric weights, types of fabric etc.
Not only does Boss it dry your clothes more quickly but it is removes creases & softens your laundry whilst being kind to your skin.
How does Boss it work?
A tumble dryer works by blowing hot air on a small area of the dryer drum, which is very inefficient.Our patented ultra-reflective tech redistributes heat around the drum by bouncing heat back into your laundry, reducing the time and energy required to dry it.
Why is Boss it better than other dryer balls?
Other dryer balls help air circulation, but they also absorb a lot of heat and reflect none.Boss it allows hot air to circulate but won’t absorb heat, it reflects it into the wet load.Making it faster at drying clothes than other dryer balls.
How is Boss it ‘climate positive’?
We looked at the amount of CO2 required to manufacture, pack and transport the ball. Then we looked at the net saving of CO2 with a 25% worse case reduction in energy use by using Boss It.In a typical vented dryer, the saving in CO2 per year through using Boss It would be about 36kg.That means that if everyone in the UK with a tumble dryer, has Boss it - that is the equivalent to planting 25,000,000 trees!
How do you use Boss it laundry dryer balls?
It's simple, just pop the ball in the dryer with your washing. If you have a sensor you simply add and run, but with timer settings you would need to reduce compared to what you normally do, so if you normally set for 60 minutes for example, you would typically need to set for 45 minutes.
I have a washer dryer. Can it go through a wash cycle?
For washer dryers, do not put the ball in during the wash cycle.Pop the ball into the drum after your wash cycle has finished.If you do leave it in the machine during the washing cycle, it will shorten the life of HeatBounce coating.Remember to take the ball out of the machine before the next wash.
How big is it?
The ball is 8cm which makes it the perfect size and weight to reflect the optium amount of heat.
How many do you use in each load of drying?
You just need one ball per machine. Make sure to remove any other dryer balls to let Boss it do it’s thing.
How long does a ball last?
Over time the ball loses its effectiveness as the Heatbounce™ coating wears off. A red outline will start to appear and be ready to be replaced in 150 cycles.
What do I do when I see dark underneath?
This means Heatbounce™ coating has started to wear off. When you have an outline on Boss it, it is time to be replaced as it's not working properly. When your ball isn't saving you money anymore, send it back to us and we will recoat it for someone else.
Send to:
Unit 18a&b Redbrook Business Park, Wilthorpe Rd, Barnsley, S75 1JN
Does the ball get hot?
Since the ball reflects heat, it can a little hot, we recommend to not touch the ball for a minute or two just after the cycle has finished.